NIKKEN CARBIDE PF RADICAL REAMER EVO
Specially designed for the material difficult-to-cut.
■ Machining Result ■ Especially for nickel-based alloys and titanium alloys such as Inconel®, Hastelloy® and Waspaloy®. ■ Smooth cutting capability and special coating to protect the base material from cutting heat and deposition. Radical Mill Reamer EVO is a reamer dedicated to the materials difficult-to-cut. Hastelloy ® C276 equivalent （ HB180 ） φ 10 mm V=18m/min, f=0.2mm/rev → φ 10 mm within H7 and Ra0.3 Inconel ® 718 equivalent （ HB250 ～ 280 ） φ 10 mm V=5m/min, f=0.2mm/rev → φ 10 mm within H7 and Rz6.3
Photo shows Radical Mill Reamer PF-RMSS-EVO Inconel ® 65 equivalent （ HB210 ） φ 4mm V=10m/min, f=0.1mm/rev, Hole depth12mm 1000 holes could be done. ■ The latest advanced coating technology has been incorporated into the Radical Mill Reamer EVO. ● The angle of the cutting edge is optimized for the materials difficult-to-cut. ● Highly deposition-resistant coating was used with a heat resistance of 1100°C and a film hardness of 3200 HV. ● Even though the arc evaporation, the droplets and pin holes are extremly reduced and smooth cutting surface can be done.
NIKKEN CARBIDE PF SPECTRUM REAMER SPX
The newest reamer for aluminum and nonferrous metals with SPX coating
Features of SPX coating （ Hydrogen-Free DLC ） ■ High level of hardness High hardness level (6000 HV) has been achieved using a Hydrogen-Free DLC coating , which contains no hydrogen at the time of deposition. The hardness is extremely close to that of a diamond. (The hardness of conventional diamond-like carbon (DLC) coatings is approximately 3000 HV.) ■ Heat resistance Coating for physical vapor deposition (PVD) adopting special filtering technology allows for a highly heat-resistant coating with few impurities and with heat resistance of 550°C. (The heat resistance of conventional diamond-like carbon (DLC) coatings the heat resistance is approximately 300°C.) ■ High efficiency performance The film thickness is 1µm or less, therefore it does not effect to cutting performance. The coating with superior slilding performance and adhered strongly on the base material suppress heat generation when reaming and long tool life can be realized.
Photo shows Radical Mill Reamer PF-RMSS-SPX
■ The "Spectrum Reamer" is … ● This is a special new reamer for aluminum, cast aluminum, nonferrous metals and resin, with a new type of Hydrogen-Free SPX (new coating), which has thin film with a high level of hardness, and totally different from conventional DLC contained hydrogen. ● The angle of the cutting edge has been optimized for the work materials and SPX coating.
306
Powered by FlippingBook