MEASURING ATTACHMENT
P. 141
Pioneer for Work Preparation
3D Sensor
UMTX Internal Contact System
HP- 50K
Height Presetter No need of test cut! Basic position of workpiece can be measured quickly without damaging tool teeth. The distance from reference surface to tool end can be measured very quickly and accurately. This is a MUST for M/C, NC Lathe and NC Milling Machine.
Micro-Touch This is 3D sensor enabling instantaneous detection of position, measurement and alignment of center by means of Red Lamp and Electric Beep. The Red Lamp lights the moment when the stylus touches a measurement part. Owing to the conductive detection system, a time delay caused by a relay etc. is eliminated and a highly sensitive measurement can be made.
Small Measuring Tool, but Great Time-Saver
Easy Micron Check
Micro-Stand Free flexing with single knob, no dead angle and long reach. Two arms incorporating ball joint mechanism at both ends provide free movement in any direction such as vertical, lateral, longitudinal or rotational etc. If stretched horizontally, a reach as long as 300mm can be attached. Measurements of inside dia., outside dia., end face and back face etc. can be made at will.
Touch Point Highly sensitive electronic edge finder.
Ideal for Milling Machine, Boring Machine, Drilling Machine as well as Machining Center. Instant indication by LED lamp at very light
contact of sensor ball with workpiece. Easy location of work face, O.D., I.D.
27
Powered by FlippingBook