SPINDLE FLANGE CLEANER
Spindle Flange Cleaner for Tooling and NC5 Tooling. Let's clean your spindle flange just before the fine machining to keep ATC repeatability accuracy higher. Do not rotate your spindle, just supply the 0.5MPa dry air from the stopper block in approx. 30sec., then the intermittent jet air blow from the spindle flange cleaner will clean your spindle flange surface.
92 （ 113 ）
MBT40-CLEF- 92 MBT50-CLEF-113 MIT40-CLEF- 92 M I T50-CLEF-113
R41.5 （ R50 ）
Jet Air Blow
60 （ 82 ）
Air Supply Port
CLEF
R15
（ ） : MBT 50 , MIT50
★ Stopper Block is not included. When ordering, please specify the name of M/C builder, model No. and the drawing of the spindle flange. P.324
SPINDLE TAPER CLEANER
Let's clean your spindle taper just before the fine machining. Rotate your spindle at 50 ～ 150r/min, then the spindle cleaner will rotate to clean your spindle taper. Please be careful, MAX. rotation speed of your spindle is 150r/min.
Deer Skin
BT40-CLE-100 BT50-CLE-120 I T40-CLE-100 I T50-CLE-120
Special Pull Stud
for CLE Cleaner
75 ( 92 )
CLE
★ Special Pull Stud for CLE Cleaner is supplied as standard. Please specify the Pull Stud Code No. ★ Stopper Block is not included. When ordering, please specify the name of M/C builder, model No. and the drawing of the spindle flange. P.324
AUTOMATIC OIL SUPPLY HOLDER
For Improvement of Tap run-out accuracy and extended tap life. Automatic oil or grease supply of a required amount can be done with this holder before your tapping operation.
ZP
Discharge / Stroke 0 ～ 3.0 cm 3 0 ～ 3.5 cm 3 0 ～ 3.5 cm 3
Capacity of tank
Weight （ kg ）
Nozzle (Standard Accessories) ZP-10, ZP-10G, ZP-20
φ D 1 60 80 96
φ D 2 64 84 100
Code No.
L
TAPER No.30 No.40 No.50
BT30-ZP60-200 BT40-ZP80-279 BT50-ZP95-312
200 279 312
100 cm 3 300 cm 3 500 cm 3
1.2 3.3 6.0
ZP-10, ZP-10G, ZP-20, ZP-30
167
Powered by FlippingBook